1. The shaking phenomenon occurs on each axis of the hand crank. It turns out that there is a problem with the circuit board inside the hand wheel box, and the damaged components can be replaced.
2, the hand wheel is sometimes easy to use, sometimes it is not easy to use, there is no law. It turns out that the resistance inside the hand wheel or the handwheel extension line is too large, and the problem of replacing the spare line is solved.
3, the hand wheel reaction is not sensitive, there is a serious pulse loss phenomenon, the original pin is not in place at the plug connection.
4, the hand wheel can not be used, the original plug of the signal line A / B that is X1/X2 plugged in reverse.
5, the hand wheel can not be used or the hand wheel has a pulse loss phenomenon, the original cable splitter jump needle is wrong, should jump on both sides to stay in the middle.
6, the hand wheel can not be used or the hand wheel has a pulse loss phenomenon, the signal cable 6FX2002-4AA21-0xx0, there is a broken line or virtual connection.
7, the hand wheel can not be used, the original pulse generator is broken, can only be replaced.